2oz FLOCK IT! Root Blast
Nick Chavez’ FLOCK IT! Root Blast for wet or dry hair is a perfect root lift mousse. Just shake it and FLOCK IT! Creates amazing lift, volume and texture. Directions for use: Spray a quarter sized amount or as needed into hands, apply on damp hair from scalp to ends, then blow dry. On dry hair, scrunch into hair for a texturized, piece-y look. Great for locking in curls and locking out frizz.
PLEASE REFER TO THESE DIRECTIONS WHEN USING THE FLOCK IT! Root Blast - Directions for use: Product is temperature sensitive, please bring product to room temperature before use. Shake the can well. Prime the can by spraying 3-5 short bursts into the sink. Shake can again. Spray a quarter sized amount or as needed into hands, apply on damp hair from scalp to ends, then blow dry. On dry hair, scrunch into hair for a texturized, piecy look. Great for locking in curls and locking out frizz.
Ingredients: Water/Aqua/Eau, Hydrofluorocarbon 152a, Isobutane, Polyquaternium-4/Hydroxypropyl Starch Copolymer, PVP, Corn Starch Modified, PEG-40 Hydrogenated Castor Oil, PPG-5-Ceteth-20, PEG-12 Dimethicone, Cetrimonium Chloride, Laureth-4, Alcohol Denat., Polyurethane-14, AMP-Acrylates Copolymer, Aminomethyl Propanol, Polyquaternium-7, Sodium Benzoate, Trimethylsiloxyamodimethicone, C11-15 Pareth-7, C12-16 Pareth-9, Glycerin, Trideceth-12, Phenoxyethanol, Caprylyl Glycol, Ethylhexylglycerin, Hexylene Glycol, Tetrasodium EDTA, Fragrance/Parfum, Limonene, Amyl Cinnamal, Linalool, Benzyl Salicylate, Citronellol, Panthenol, Ethylhexyl Methoxycinnamate.
DANGER: Extremely flammable aerosol. Pressurized container: May burst if heated. Keep out of reach of children. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.
TO AVOID CLOGGING NOZZLES, MAKE SURE THE OVERCAP IS PLACED ON THE CAN WHEN NOT IN USE. IF THERE IS CLOGGING, RUN THE NOZZLE UNDER HOT WATER TO REMOVE PRODUCT BUILDUP.